Notifications
Clear all

Calibration issues  

  RSS
brent.g
(@brent-g)
New Member
Calibration issues

Took a video of calibration as it started acting weird. Seems to climb away from the plate. When I try to manually adjust z it only goes up.

http://vid.me/ho7c

On further inspection it seems my pinda probe isn't lighting up and a self test returns an end stop z error. I'm thinking the probe has gone bad?

Posted : 22/07/2016 6:18 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Calibration issues

Hi Brent

Contact support - use "Live Chat" on the shop page. Give them a link to this thread.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 22/07/2016 9:19 am
Share: