Notifiche
Cancella tutti

Buy an heatbed for the Prusa MK2  

  RSS
tetranet
(@tetranet)
Active Member
Buy an heatbed for the Prusa MK2

HEllo,

Is it possible to buy just the HeatBed ? i can't find on the store.

Thanks

Marc

Postato : 03/07/2016 9:09 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Buy an heatbed for the Prusa MK2

Marc

You need to send an email to support and explain your problem.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Postato : 03/07/2016 9:41 am
tetranet
(@tetranet)
Active Member
Topic starter answered:
Re: Buy an heatbed for the Prusa MK2

ok Thanx Peter 🙂

Postato : 03/07/2016 6:41 pm
alfioscuderi1978
(@alfioscuderi1978)
Active Member
Re: Buy an heatbed for the Prusa MK2

I've already asked to support team and they answered me that they haven't any other heatbed available.
They have one heatbed for every kit, so they can't sell you others heatbed!

Anyway, let me know if you've different info.

Bye!

Postato : 04/07/2016 9:29 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Buy an heatbed for the Prusa MK2

Hi Alfio

Yes, that is indeed the situation. Unfortunately, the bed manufacturers cannot produce sufficient to satisfy demand.

I think that when the initial surge of orders dies down then the spares will become available.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Postato : 04/07/2016 9:36 am
alfioscuderi1978
(@alfioscuderi1978)
Active Member
Re: Buy an heatbed for the Prusa MK2

Hi Alfio

Yes, that is indeed the situation. Unfortunately, the bed manufacturers cannot produce sufficient to satisfy demand.

I think that when the initial surge of orders dies down then the spares will become available.

Peter

Yes, Peter, I confirm what you said: the support team confirmed me that when the orders will be "calmer", the heatbed will be sold in the shop site. Let's hope...! 🙂

Bye,
Alfio

Postato : 04/07/2016 9:41 am
Mike C
(@mike-c-2)
Eminent Member
Re: Buy an heatbed for the Prusa MK2

Good to know, thanks for looking into this. I also need one, at some point the extruder lowered too much and put a dimple in the bed and and then scarred it to the end. I can print away from that area but really want to replace it.

Postato : 06/07/2016 7:06 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Buy an heatbed for the Prusa MK2

Mike

You don't need a new bed for that, just a PEI sheet with adhesive. I think you will have to supply your own limonene to remove the existing adhesive.

Contact support (live chat) to see if the PEI sheets are available.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Postato : 06/07/2016 7:16 pm
Condividi: