Bed thermal runaway error
Hi Everyone,
Yesterday I had my first fail in the first week using my new assembled Prusa Mk2s. It was an overnight print (silent mode, PETG filament).
When I checked in the morning, the bed was a complete mess. Filament all over the nozzle area, really horrible. I preheated the nozzle and scraped most of the filament out but it's still looking not as nice.
Anyway, I tried to print something again today after cleaning and now all prints are stopping at some point with the "Bed Thermal Runaway" error. Does anyone have experience with it? Any thoughts? Is the printer damaged?
PS: Noob here when it comes to 3d printer engineering so I really don't know what to do.
PS2: Before the fail, I had PETG successful prints before just using the PET preset, no changes at all (Slic3r)
Re: Bed thermal runaway error
Plenty of references to this if you search the forum: http://shop.prusa3d.com/forum/search.php?keywords=bed+thermal+runaway
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…