Benachrichtigungen
Alles löschen

Bed leveling not working?  

Seite 2 / 2
  RSS
Nigel
(@nigel)
Honorable Member
Re: Bed leveling not working?

@patrick.s13 I agree Duet WiFi maybe the way to go. I use Duet Ethernet electronics provided by think3dprint3d on my first homebuilt printer, now over two years old, a Kossel Mini, provided by think3dprint3d here in the UK. Original electronics were a Mega Arduino with a Ramps board.

I upgraded it over the years, including to Duet electronics, as provided by think3dprint3d I control my Kossel printer via a web interface over ethernet on my local network. My friend has the new Duet Wifi electronics.

Nigel
Life is keeping interested and excited by knowledge and new things.

Veröffentlicht : 04/04/2017 3:47 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Bed leveling not working?

But the Duet firmware will not include most of the Mk2 features and I will not spend £120 just to see if I can get it working.

If I can get the Mk2 firmware working on a Due, the Duet then becomes an option.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Veröffentlicht : 04/04/2017 11:57 am
Nigel
(@nigel)
Honorable Member
Re: Bed leveling not working?

OK Peter, Fair enough about the cost of the Duet Board. Keep us posted on how you get on with an Arduino Due Board. I'm interested.

Nigel
Life is keeping interested and excited by knowledge and new things.

Veröffentlicht : 07/04/2017 3:12 am
Seite 2 / 2
Teilen: