Advice and Settings for printing Ninjaflex?
 
Notifiche
Cancella tutti

[Chiuso] Advice and Settings for printing Ninjaflex?  

Pagina 2 / 2
  RSS
Yann04
(@yann04)
Eminent Member
Re: Advice and Settings for printing Ninjaflex?

Re: Advice and Settings for printing Ninjaflex?
Mark answer Rapporter le messageCitation
juin 12, 2016 3:31 pm

What are the exact problems?

Set very low tension on the extruder springs, turn off retract and slow the printer a bit (you can test this on the LCD panel)

Our flex is much easier to print and can run on PLA settings 🙂
--------------------------------------------------------------------
Founder and owner / Majitel a zakladatel
[email protected]

I am a very beginner with only 3 parts PLA printed since I get my mk3.
How do you slow the printer a bit ? What does it mean ?

When I open Slicer I have all those different speeds :

I guess Josef mean to reduce all those speeds from the LCD Menu during the printing, isn't it ?

Postato : 26/01/2019 7:45 pm
Pagina 2 / 2
Condividi: