Adjusting live Z?
When adjusting live Z what value change means closer to the bed vs. further from the bed?
If I am at -.240 and move it to -.250 is that moving it away from the bed?
Re: Adjusting live Z?
The value represents nozzle height. So more negative value means "go down".
Re: Adjusting live Z?
Ok, so just to clarify, -.25 is closer to the bed than -.24?
Re: Adjusting live Z?
Yes, that is correct.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: Adjusting live Z?
Great, thanks. I somehow got this mixed up!
Re: Adjusting live Z?
Great, thanks. I somehow got this mixed up!
Yes, it is very easy to get it wrong. Then the "bed level corrections" add another level of complexity. And I don't think it is properly explained anywhere.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…