Notifications
Clear all
trouble with Prima PVA+ debonding, need tips!
Hi, I'm struggling to use PrimaSelect PVA+ as MM support material - I keep having problems where an entire layer will debond and ruin the print.
In trying to figure out whats wrong, I printed a small object in vase mode to see if there are any clues - turns out there are 🙂
I'm new to PVA+ and hoping someone can give me a few ideas.
I'm printing these at 195C, which is the default in Slic3r and somewhere in the middle of what Prima recommends (180->210C)
tips?
Opublikowany : 22/10/2017 8:44 pm