Message -wait for user - during print
I Print my first Multi Material Object - the Marvin. On this Print the printer stops occassionaly with the message "whait for user" 😕 .
In this time the printer stays on the place, temparatur is holding.
Press the knob resume print.
What can i do. I'm not sitting beside the printer all the Time?
Re: Message -wait for user - during print
I just saw this today. 9 hours into a print off the SD card. The print head was paused over the waste tower and "wait for user" (or something similar) was displayed on the LCD. A push on the knob started it back up again.
Anyone?
Re: Message -wait for user - during print
I have never seen this behavior, so I am guessing:
1) Make sure the Firmware you installed is the correct one for the MMU. Not the MK2.
2) Make sure the file you are printing is the MMU version.
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Re: Message -wait for user - during print
There is already other threads opened on this subject, check https://shop.prusa3d.com/forum/original-prusa-i3-mk2-multi-material-f26/-wait-for-user--t6774.html#p55246 for example. Please respond if you have a Raspberry Pi connected to the printer when this happens to you.