Notifications
Clear all

Extruder Toolchange Gcode?  

  RSS
devilhunter
(@devilhunter)
Reputable Member
Extruder Toolchange Gcode?

I'd like to use Extruder #3 for EDGE and Extruder #4 for Scaffold, and currently when i make a multi material print this way the start strip gets created with Extruder #1 (not in use).

After it made the landing strip with Extruder #1 it rams in the EDGE filament from E3 (which of course comes about 5cm too late.

What can i set in the starting gcode so that it makes the landing strip with Extruder #3?

Posted : 26/07/2017 1:09 pm
Share: