Avisos
Vaciar todo
Adalina part to extruder map?
Can anyone tell me which extruder prints which part in the Adalina gcode? I want to assign the biggest piece to the filament I have the most of. Thanks .
Respondido : 17/09/2017 12:57 am
Re: Adalina part to extruder map?
I don't know, but it is likely the same as the .amf file found here:
https://www.thingiverse.com/thing:2386054/#files
(This is my guess - I have not printed the included .gcode file.)
This has been asked here before. If you verify that it is in-fact the same as this .amf file, please post here for the next person who asks.
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Respondido : 17/09/2017 1:26 am