Avisos
Vaciar todo

Slic3r PE v1.41.0+ "File not complete" issue  

  RSS
speedaemon
(@speedaemon)
Active Member
Slic3r PE v1.41.0+ "File not complete" issue

I recently upgraded to Slic3r PE v1.41.0+. Every time I print a file now, I get a warning "This file is not complete, print anyway?". There are no problems if I say "yes", but I keep forgetting about that last prompt and walking away, only to wonder 10min later why I don't hear my printer going.

It looks like this version is appending a commented out section at the end of the gcode file, with all the settings used to generate the file. Which is pretty cool, except for the printer warning.

Is there a setting in Slic3r to turn this off, or change where it puts the comments? Or does upgrading to the next beta Slic3r fix this?

-Sarkis-

Respondido : 12/10/2018 9:44 pm
Compartir: