Notifications
Clear all
Additional load attempt, excess filament on wipe tower
Hi,
Many times when the MMU is changing filament, excess filament is extruded on the tower, something so much that the subsequent layer of the wipe tower cause a crash or wipe tower is knocked off the build plate.
I suspect the IR Sensor is not registering the changed filament ?
Any other suggestions ?
Regards,
Brendan
Attachment removed
Opublikowany : 26/05/2019 4:58 pm
Topic starter
answered:
RE: Additional load attempt, excess filament on wipe tower
more
Attachment removed
Opublikowany : 26/05/2019 4:58 pm
Topic starter
answered:
RE: Additional load attempt, excess filament on wipe tower
More
Attachment removed
Opublikowany : 26/05/2019 4:59 pm
Topic starter
answered:
RE: Additional load attempt, excess filament on wipe tower
Calibrated the IR Sensor and did a successful print with 61 changes.
Opublikowany : 26/05/2019 8:23 pm