5mm walls in a model, start to lean and bulge where they meet flat surface. They should be vertical. Any help?
 
Notifiche
Cancella tutti

5mm walls in a model, start to lean and bulge where they meet flat surface. They should be vertical. Any help?  

  RSS
diogorsergio
(@diogorsergio)
New Member
5mm walls in a model, start to lean and bulge where they meet flat surface. They should be vertical. Any help?

Hi guys,

I'm trying to pring the following piece.

But I can't seem to get those two "towers" to line up vertically. The print stars from there, and goes up. What can I do to fix, or minimize this? Any ideas?

It was printed on a MK2, the gap had a lot of supports can they be causing this?

Cheers!

Postato : 02/12/2018 1:27 am
Condividi: