Notifications
Clear all

Printer rebooting at startup since yesterday  

  RSS
toti
 toti
(@toti)
Active Member
Printer rebooting at startup since yesterday

Hi, since yesterday my prusa i3 mk2 is rebooting all the time. I can only see "original prusa 3d printers", and less than a second it's rebooting and showing the message again. The z motors seems to do a little sound, so I disconnected the z motors from the mainboard. If I disconnect the z motors, the print starts as usual, but if I connect only one of the z motors connectors, the printer starts rebooting again. It's a motherboard issue?

thanks

jordi

Opublikowany : 16/06/2018 4:59 pm
toti
 toti
(@toti)
Active Member
Topic starter answered:
Re: Printer rebooting at startup since yesterday

Yes, it's a motherborboard issue. If I connect x or y motors to the z slots, the printer reboots. If I connect the z motor into the x or y connector not. How can I get a new motherboard? It's the printer still on guarantee? (its from january 2017)

Opublikowany : 16/06/2018 5:11 pm
Share: