Notifications
Clear all
Need a new hotend?
Afetr getting the old MK2S up and runnning again, I noticed that the extruder temp is vacillating more than I remember. For a set temp of 210, it jumps between 214 and 208 or so.. I don't rememeber it ever being this unsteady.. If this normal or should I be looking at replacement?
Regards
Publié : 22/10/2018 5:50 am
Re: Need a new hotend?
That is not to much I think.
PID-tuning will even make that a bit better...
Publié : 22/10/2018 9:41 am
Re: Need a new hotend?
Normal.
Publié : 22/10/2018 12:39 pm