Notifications
Clear all
Extruder Fan Issue
This is going to seem weird. I'm having an issue with the extruder fan turning off when preheating the printer to change filament. I have the MK2/S and the issue started after upgrading to 3.1.0. for the firmware. The fan will start fine when I first tell the printer to preheat PLA. After it reaches 210, the fan will stay on for a few minutes, but then will just stop. If I tell the printer to cool down, the fan will turn back on at 55 degrees. If I turn the printer off and back on, the fan immediately starts. I have never had the fan go out on a print. Again only happens with the preheat. Any thoughts?
Napsal : 28/08/2018 3:51 am