Are there any files for trapezoidal nut metal adaptation?
 
Notifications
Clear all

Are there any files for trapezoidal nut metal adaptation?  

  RSS
Adam Ramsey
(@adam-ramsey)
Member
Are there any files for trapezoidal nut metal adaptation?

Hey all. I was gifted an old Geeetech i3 clone. I have been upgrading it and building it into an MK2S. It's been a fun process. The old Geeetech used 1mm thread pitch threaded rod for the lead screws. I went and bought the right lead screws and the plastic trapezoidal nuts. I must have not been paying attention while fiddling with it because when I went to to assemble the gantry, one nut is cross-threaded.

It seems kinda dumb to buy another set when I have some nice metal nuts that came with the lead screws I bought. I just don't have a good way of attaching them.

I'm sure I can come up with something, I just wanted to see if anyone has any files or suggestions before I plow forward.

TIA.

Posted : 10/06/2024 12:18 pm
Share: