Slic3r Prusa Edition Infill Behavior
Hi,
I observed some strange behavior of Slic3r Prusa Edition when generating the infill paths. When slicing organic/curved shapes, Slic3r tends to make this tiny zig-zag infill. These cause my MK2S to vibrate severely!
I sliced the same part with Cura and the result is totally fine. Am i missing some settings? Can this behavior be avoided?
An example for the stated behavior are my results slicing Emmett's famous bearing (see pictures below).
https://www.thingiverse.com/thing:53451/files
Similar behavior can be observed slicing e.g. hexa_TOP.stl from this link:
https://www.thingiverse.com/thing:432829/files
Thanks for any suggestions!
Cheers
Re: Slic3r Prusa Edition Infill Behavior
This is caused by the Ensure vertical shell thickness setting. Take the check mark off the box and reslice.
