Notifiche
Cancella tutti

first layers shifting  

  RSS
jean-pierre.v
(@jean-pierre-v)
New Member
first layers shifting

About the 10 first layers (1 mm thick) are shifting away before printing straight. Any suggestions ?

Postato : 20/06/2018 4:45 pm
MintShard
(@mintshard)
Utenti
Re: first layers shifting

Check the set screws for your X and Y pulleys. I was experiencing this issue recently and it was because the screw that lines up with the flat of the motor shaft was loose.

Postato : 20/06/2018 4:53 pm
Condividi: