Notifications
Clear all

unload filament  

  RSS
pj
 pj
(@pj)
Eminent Member
unload filament

Od FW 3.0.9 mám velmi krátký Unload filament příkaz. Musím opakovat 3x až 4x. Při běžném provozu to nevadí, ale u výměn barev to vadí dost. V kódu je M600, která má danou sekvenci. Je to FW bug?

Posted : 15/01/2017 8:53 am
miroslav.h4
(@miroslav-h4)
Honorable Member
Re: unload filament

Podle mne není, na mé i3 MK2 funguje naprosto dobře. Podívej se taky zda ti dobře chladí ventilátor HE (ten malý boční).

Posted : 15/01/2017 10:53 am
eddie.k
(@eddie-k)
Active Member
Re: fluctuating temperatures

Good day can you help me please. This is my scenario:

Download a file into Repetier Host and slice it.
Go to my Prusa i3Mk2 and press PREHEAT then PLA 215/55
Wait for temperature read out to be 215/55
Press START PRINT on my computer program and immediately bed temperature changes to 59/105
Go to TUNE and manually change temp to 55
Printer starts to do 9 point check but Nozzle temp changes to 240 deg
Go to TUNE and manually change nozzle temp back to 215 deg.

Every time I do anything on the Repetier software the temperature changes

Thanks
Eddie
[email protected]
Durban South Africa

Posted : 04/08/2017 3:45 pm
Share: