Notifications
Clear all
problem extruder
pri tisku mi vyteka mala cast filamentu i v tomto prostoru extruderu, je poskozen nebo nejake tesneni ? da nejak opravit, nebo koupit novy?
Opublikowany : 20/03/2019 2:31 pm
Re: problem extruder
If you replaced the nozzle, did you tighten when the nozzle was HOT (280c)?
Also, did you ensure the nozzle was tightened against the heat break, not the heater block? The nozzle HEX must not touch the block.
Opublikowany : 21/03/2019 2:34 pm