Avisos
Vaciar todo

wire disconnected during assembly  

  RSS
fabio.b4
(@fabio-b4)
New Member
wire disconnected during assembly

😮 😕
Hi, During assembly I inadvertently detached a wire
do you think it is possible to repair it or is it possible to replace only the broken piece?
Thanks for your help
Valter.

Respondido : 16/08/2018 10:33 am
BillC
(@billc)
Reputable Member
Re: wire disconnected during assembly

sorry but that connection cannot be repaired. That is the heater cartridge which happily can be replaced. Available on Prusa eshop and also from E3D. Make sure you get the right one for your printer Mk2/S uses 12V 40W, Mk3 uses 24V.

Bill
Tagaytay City, Philippines
Founder member of Philippines Prusa Printer Owners FB Group
Sponsor Pillars of God Academy in Bacoor

Respondido : 16/08/2018 12:22 pm
fabio.b4
(@fabio-b4)
New Member
Topic starter answered:
Re: wire disconnected during assembly


sorry but that connection cannot be repaired. That is the heater cartridge which happily can be replaced. Available on Prusa eshop and also from E3D. Make sure you get the right one for your printer Mk2/S uses 12V 40W, Mk3 uses 24V.

Thanks for reply Bill
I just bought this:
HICTOP cartuccia riscaldatore 12 V 40 W 3pcs per stampante 3D Prusa i3 Mendel
I hope it's okay
bye, Valter

Respondido : 16/08/2018 12:42 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: wire disconnected during assembly

Personally, I would stick with original E3D parts; you know they will fit and are relatively safe to use.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Respondido : 16/08/2018 2:46 pm
Compartir: