[Résolu] Too tight belts = Rambo overheats?

Dernier message

RSS

vit.h3

(@vit-h3)

New Member

Too tight belts = Rambo overheats?

Today, I tighten X and Y belts in order to prevent layers shifts that were appearing more and more often.

First (approx 30min) print was OK, but during the second one, I started to feel wierd smell comming from Rambo. Rambo was totally hot all over the board. After cooling down and anothet run, the result was completely the same - slight smell and hot Rambo.

I disassembled Rambo and did inspection - no burns, all connectors OK.

Could really over-tightening the belts cause this? Do stepmotors need more power and thus Rambo overheats?

Publié : 14/05/2020 8:13 pm

Statistiques du forum

565 Forums

63.5 K Sujets

446 K Messages

21 En-ligne

68.8 K Membres

Le dernier des messages: MK4s nextruder Cover change to MK4 cover without the ring? Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé