Overkill?

Dernier message

RSS

3d Bunny

(@3d-bunny)

New Member

Overkill?

Printed y corner in st pla (no access to petg ) to replace cracked one. didn't like outcome. Made it out of brass. Btw newbie to both 3d printing and mini mill.

Publié : 07/10/2020 11:18 am

Clemens M.

(@clemens-m)

Noble Member

RE: Overkill?

Nicely done, as far as the production of the part is concerned. Unfortunately the frame of the MK2x is not exactly a technical masterpiece. So if you have such manufacturing capabilities like you have, you could really let off steam here!

Best regards, Clemens

Mini, i3 MK2.5S, i3 MK4, CClone (Eigenbau)

Publié : 09/10/2020 5:18 am

Statistiques du forum

559 Forums

62.9 K Sujets

442.9 K Messages

19 En-ligne

67.7 K Membres

Le dernier des messages: How to pause during gcode printing Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé