Octoprint Problem

Dernier message

RSS

poleinew

(@poleinew)

New Member

Octoprint Problem

Hello,

I created an Octopi setup just for the timelapse recording. Normally, prints are nearly perfect but when I connect Printer to Octopi, printer calibration is breaking. Z axis doesn't go to its right position.

Also, I'm receiving firmware error on Octopi's main page. I'm using stock firmware (1.0.2) and I'm not using BLTouch or Filament Detection sensor. I just want to take timelapse record for my print process, that's all. I'm still using the SD card .

Publié : 14/10/2021 2:32 pm

poleinew

(@poleinew)

New Member

Topic starter answered:

Solved.

Posted by: @poleinew

Hello,

I created an Octopi setup just for the timelapse recording. Normally, prints are nearly perfect but when I connect Printer to Octopi, printer calibration is breaking. Z axis doesn't go to its right position.

Also, I'm receiving firmware error applinked on Octopi's main page. I'm using stock firmware (1.0.2) and I'm not using BLTouch or Filament Detection sensor. I just want to take timelapse record for my print process, that's all. I'm still using the SD card .

Thanks. Issue solved.

Publié : 18/10/2021 4:11 pm

Statistiques du forum

565 Forums

63.5 K Sujets

445.9 K Messages

21 En-ligne

68.8 K Membres

Le dernier des messages: Aide à l'impression du TPU 95A ou 98A Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé