English
Forums
English forum
Original Prusa i3 MK2.5 & MK2.5S
User mods - OctoPrint, enclosures, nozzles, ...
Octoprint Problem
 
Notifications
Clear all

Octoprint Problem  

    Last Post
  RSS
poleinew
 poleinew
(@poleinew)
New Member
Octoprint Problem

Hello,

I created an Octopi setup just for the timelapse recording. Normally, prints are nearly perfect but when I connect Printer to Octopi, printer calibration is breaking. Z axis doesn't go to its right position.

Also, I'm receiving firmware error on Octopi's main page. I'm using stock firmware (1.0.2) and I'm not using BLTouch or Filament Detection sensor. I just want to take timelapse record for my print process, that's all. I'm still using the SD card .

Posted : 14/10/2021 2:32 pm
poleinew
 poleinew
(@poleinew)
New Member
Topic starter answered:
Solved.

 

Posted by: @poleinew

Hello,

I created an Octopi setup just for the timelapse recording. Normally, prints are nearly perfect but when I connect Printer to Octopi, printer calibration is breaking. Z axis doesn't go to its right position.

Also, I'm receiving firmware error applinked on Octopi's main page. I'm using stock firmware (1.0.2) and I'm not using BLTouch or Filament Detection sensor. I just want to take timelapse record for my print process, that's all. I'm still using the SD card .

Thanks. Issue solved.

Posted : 18/10/2021 4:11 pm
  All forum topics
  Previous Topic
Next Topic  
Share: