Benachrichtigungen
Alles löschen
Printing the Support Material Interface without the rest of the Support material
Hello,
Is there a way to make Prusa just print the support interact as its shown below (image 1) rather than with the whole support structure( image 2) this is simply to make the printer faster and waste less plastic.
(image 1)
(image 2)
Thanks for any help 🙂
Veröffentlicht : 18/08/2021 3:42 pm
Build page support
I am not sure I fully see what you are request, but the only thing I can think of is building from the build plate one.
--------------------
Chuck H
3D Printer Review Blog
Veröffentlicht : 18/08/2021 8:23 pm
Themenstarter answered:
Support
I mean for it not to build from the build plate, so it also puts support in the gap without wasting loads building up the support from the plate
Veröffentlicht : 20/08/2021 9:38 am