Printing 2.5 Upgrade Parts (Cubic not Grid infill) Possibly dumb question.
I got a bit ahead of myself and when my upgrade kit arrived I just started printing the bits straight away. I have now completed about 75% of them and then glanced at the printing instructions which said to use grid infill at 20%.
Ive printed them all so far in cubic.
Now I know cubic is stronger than grid but knowing Prusa they probably specified grid for a reason.
Have I done messed up? Should I print them all again using grid infill?
RE: Printing 2.5 Upgrade Parts (Cubic not Grid infill) Possibly dumb question.
Anyone?
RE: Printing 2.5 Upgrade Parts (Cubic not Grid infill) Possibly dumb question.
Hi
I printed all of my 2.5 parts in Cubic at 25% with 3 perimeters..... doesn't seem to matter, or at least it assembled well and works fine.
¡no entiendo Español!
Nein! Nicht Versteh!
Я немного говорю по-руÑÑки но не очень хорошо, и...
I'm not very good at English either! Maybe someday I'll find a language I'm good at?