Notifications
Clear all
Irregular first layer problem
I have changed speed, changed Z height, changed temp of both bed and extruder but keep getting same problem. Happens with both PLA and PETG. Do I have a heat bed problem? Or am I missing something?
Napsal : 19/01/2023 1:44 am
Your first layer 'Z' offset is calibrated a little too low. It looks like there are fingerprints on the build sheet in a couple of places near the edges.
Cheerio,
Napsal : 19/01/2023 5:50 am
Topic starter
answered:
RE: Irregular first layer problem
I clean my bed with alcohol between each printing. I will try again to adjust my Z axis offset. Have messed with this before but did not solve problem. Will advise
Thanks for the answer.
Napsal : 20/01/2023 3:44 am
I clean my bed with alcohol between each printing
If that's not shifting it then it's time for the dishwashing detergent (Dawn/Fairy) and plenty of HOT water.
Cheerio,
Napsal : 20/01/2023 10:45 pm