Français
Forums
English forum
Original Prusa i3 MK2.5 & MK2.5S
Hardware, firmware and software help
Upgrade from 3-5-7 to 3-7-0 : unable to find first calibration point
 
Notifications
Clear all

Upgrade from 3-5-7 to 3-7-0 : unable to find first calibration point  

    Dernier message
  RSS
PeP
 PeP
(@pep)
Active Member
Upgrade from 3-5-7 to 3-7-0 : unable to find first calibration point

Hi there,

I try upgrading my MK2.5s from 3-5-7 to 3-7-0. Everything went fine... until XYZ calibration.

Wizard stop because it was unable to find the first calibration point.

I revert to 3-5-7 and everything went fine!

Any guess on this ?

Publié : 28/04/2019 4:39 pm
PeP
 PeP
(@pep)
Active Member
Topic starter answered:
RE: Upgrade from 3-5-2 to 3-7-0 : unable to find first calibration point

Sorry, it was 3-5-2, not 3-5-7...

Publié : 28/04/2019 4:45 pm
  Tous les sujets du forum
  Sujet précédent
Sujet suivant  
Partager :