Notifications
Clear all
PINDA probe calibration/ Temp. calibration issue
I'm using the 3.4.0 firmware on my MK2.5 which otherwise operates great as far as I can tell.
I have twice attempted to run the Temp Calibration from the LCD Calibration menu and it stays stuck on 1/6. I assume this means 1 of 6. I have let it sit overnight and it does not proceed beyond this. The bed heats to 75° and fluctuates slowly to 76° and 74°. Mostly it stays dead on 75°.
Anyone else seen this? Is there something I'm doing wrong?
Tom Cole
Posted : 20/09/2018 10:16 pm
Re: PINDA probe calibration/ Temp. calibration issue
i know it does that on my m3 . support said i dont need it......
I have a Prusa,therefore I research.
Posted : 05/10/2018 6:24 am