Notifications
Clear all
Inner perimeter out of path
Hi all,
I'm experiencing an odd issue on my Prusa. It's a Mk2.5s Half Bear with external extension board to mount TMC 2208 XY drivers.
Especially when doing long prints I noticed that it messes up randomly with the inner perimeter. Instead of following the path the nozzle moves, at a certain point, higher than the right height and instead of following a curve it goes straight laying the filament out the print or just on the infill.
What could be the problem?
This topic was modified před 5 years by Angelo
Angelo ZappalÃ
Napsal : 25/08/2019 6:37 am
RE: Inner perimeter out of path
Shouldn't this be posted in USER MODS?
Napsal : 25/08/2019 7:11 pm