I'm trying to change (because I have not found any other PINDA in this state (covid-19) a NC to a NO
 
Notifications
Clear all

I'm trying to change (because I have not found any other PINDA in this state (covid-19) a NC to a NO  

  RSS
aa6767
(@aa6767)
New Member
I'm trying to change (because I have not found any other PINDA in this state (covid-19) a NC to a NO

First, I tried to recompile firmware changing the const to invert behaviour of PINDA but I didn't obtain a valid hex. My printer doesn't work . Not even the menu is displayed . 

Now , I'm trying to get clear about how can I wire the PINDA to try get it working with the official firmware. But I don't know how to do it.

Has anybody did it??

Publié : 18/04/2020 11:04 am
karl-herbert
(@karl-herbert)
Illustrious Member
RE: I'm trying to change (because I have not found any other PINDA in this state (covid-19) a NC to a NO
Posted by: @aa6767

First, I tried to recompile firmware changing the const to invert behaviour of PINDA but I didn't obtain a valid hex. My printer doesn't work . Not even the menu is displayed . 

Now , I'm trying to get clear about how can I wire the PINDA to try get it working with the official firmware. But I don't know how to do it.

Has anybody did it??

Hello, welcome to the Prusaforum!

PINDA replacement for MK2 you can find here: https://www.printedsolid.com/products/pinda-1-probe-replacement

MK3 here: https://www.printedsolid.com/products/pinda-2-probe-replacement

No FW changes necessary.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Publié : 18/04/2020 2:41 pm
Partager :