Notifiche
Cancella tutti

Custom Firmware Help  

  RSS
Suat
 Suat
(@suat)
New Member
Custom Firmware Help

Hi, 

im Renan im a 18 year old student who really wanted a prusa printer but didnt have the funds so i decided to source them myself 

so after sourcing parts here and there i found a prusa bear upgrade kit so i built the bear frame and bought original motors and rambo einsy 1.1b

now i installed everything i noticed that everytime it would bed mesh level it would crash into the right side so i found out that the bear frame was meant for mk2.5 and i have a board that can only run mk3 firmware so i asked support and they told me i needed custom compiled prusa firmware but honestly i know some stuff about the marlin software but im not necesarry a pro so im asking for some help by people who have some knowledge for me making my custom firmware

 

Postato : 11/11/2022 7:21 pm
Robin
(@robin)
Noble Member
RE: Custom Firmware Help

You might need to be more specific about what kind of help you need and what you already know. I doubt that someone writes a complete „how to modify prusa firmware to your exact needs, compile it on your system and flash it to your board“ based on your post…

If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!

Postato : 12/11/2022 5:22 pm
Condividi: