Looking for Help: Printing the Parts for Upgrade
Hi all, not sure where else to post this but long story short, something happened to the printed parts I prepared for my 2.5S upgrade. Now I am without the parts and a disassembled and broken printer. Any suggestions on where to get these printed for a reasonable cost? Most online 3d printing places want $100 or more. Any suggestions or members willing to help (would compensate of course) i would appreciate it greatly!!
Thanks, Steve
RE: Looking for Help: Printing the Parts for Upgrade
Use the Prusaprinters World map to find users near you who offer printing services or technical help and PM them. It helps to give your general location when you post - otherwise no-one can tell if they are even in the same country as you without too much effort.
Bill
Tagaytay City, Philippines
Founder member of Philippines Prusa Printer Owners FB Group
Sponsor Pillars of God Academy in Bacoor
RE: Looking for Help: Printing the Parts for Upgrade
Hi all, not sure where else to post this but long story short, something happened to the printed parts I prepared for my 2.5S upgrade. Now I am without the parts and a disassembled and broken printer. Any suggestions on where to get these printed for a reasonable cost? Most online 3d printing places want $100 or more. Any suggestions or members willing to help (would compensate of course) i would appreciate it greatly!!
Thanks, Steve
Where are you from?
Best regards, Clemens
Mini, i3 MK2.5S, i3 MK4, CClone (Eigenbau)