Notifications
Clear all
X and y motors stalling after upgrade
Just finished the upgrade from 2s. Everything seemed to go fine through calibration. When i go to print though both the x and y steppers stall after the nozzle primes. Has anyone has to adjust the trim pots on the steppers after upgrading
Opublikowany : 17/11/2019 6:11 pm
RE: X and y motors stalling after upgrade
Very new to this 3d printing lark but I seem to remember seeing a thread that eventually determined that updating a 2s resulted in a 3 not a 3s. Hope this isn't nonsense or a even worse a bum steer.
Opublikowany : 18/11/2019 1:22 pm