Notifiche
Cancella tutti
Need a manual
I have a Prusa MK2 upgraded to a 2.5. I cannot load the filament because of a blockage in the hot end. I need to take the extruder unit apart to get to the blockage. I did not receive a construction manual but looked on line to build the upgrade. I did not make a copy of the manual. I went into the archives and found a manual for the upgrade. It is not the right manual. My extruder unit has two holes on the top. The online manual shows four holes and a tube. How can I get a manual for my model?
Postato : 18/10/2020 5:25 pm
RE: Need a manual
Maybe try contacting support via CHAT in the store pages. A long wait, but someone usually answers.
Postato : 18/10/2020 6:30 pm
Topic starter
answered:
RE: Need a manual
I found it online. Thanks
Postato : 19/10/2020 5:12 pm