Avisos
Vaciar todo
More print problems
This is getting messy. Every third or fourth print I do has some serious issue. I've configured everything exactly as support has asked me to and this continues to happen. I've wasted so much filament now it's not even funny. The latest disaster has more filament stuck to the nozzle than on the bed and all I'm being told to do is to repeatedly do a cold pull. I've done eleven cold pulls as of this writing and nothing helps. The problem is that this is only every fourth print so it's very, very hard to test anything. Any suggestions besides going with a different printer next time?
Respondido : 30/05/2020 6:54 pm