Notifications
Clear all
Filament stuck in fin section
Hello all,
My pla filament got stuck and stopped extruding, I checked the nozzle and it seemed to be fine, so thought it could have been stuck in a burnt end of the nylon tube.
I managed to get the tube out, but as you can see in the attached photo, the filament is still welded tight inside! Anyone know why/what I should do to fix this?
Best,
Sol
Napsal : 19/09/2018 9:35 pm
Re: Filament stuck in fin section
You might try carefully heating it with a heat gun just until the filament softens and can be pulled or pushed out. Not so much as to actually melt the filament though. Or replace the part.
Neal
Napsal : 19/09/2018 10:01 pm