Notifications
Clear all
Extruder calibration and 1st layer?
From M92: ESteps is set to 133mm
measuring the filament after extrusion, i have under extrusion.
calculated new estep at 140.
Is 133mm standard for this printer?
also, what is a typical z value for the first layer calibration?
Posted : 20/02/2023 2:55 am
RE:
Original settings for mk25 are 140 (FW 3.1.4) - see here: https://github.com/prusa3d/Prusa-Firmware/blob/MK25/Firmware/variants/1_75mm_MK25-RAMBo13a-E3Dv6full.h
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
Posted : 20/02/2023 1:35 pm
Topic starter
answered:
RE: Extruder calibration and 1st layer?
aaah ok, thankx then I will use 140mm.
Original settings for mk25 are 140 (FW 3.1.4) - see here: https://github.com/prusa3d/Prusa-Firmware/blob/MK25/Firmware/variants/1_75mm_MK25-RAMBo13a-E3Dv6full.h
wbr,
Karl
Posted : 20/02/2023 2:01 pm