Notifications
Clear all
Cheered to early
Just completed the 2.5 upgrade.
All went well according to the calibration procedure. Printed a Benchy that looked great.
But.... Why is it always a but.
Printing a live-z calibration piece i notice that the line gets wider on the right side of the square-
---
Gert
Opublikowany : 10/04/2018 8:32 pm
Topic starter
answered:
Re: Cheered to early
Pushed send to fast.. sorry.
Measuring from the top of the heat bed on bot sides i notice that the right side is about .20 mm higher?
Didn't have this issue with the MK2S bed.
Cant see anything obvious, det bed seems to be firmly down to the standoffs every where.
Any ideas?
---
Gert
Opublikowany : 10/04/2018 8:36 pm
Re: Cheered to early
Lock washers less compressed on one side?
Opublikowany : 12/04/2018 3:14 am
Topic starter
answered:
Re: Cheered to early
Im all good again.
I re-flashed the printer and the issue disappeared. Maybe it was something with the PINDA software.
---
Gert
Opublikowany : 12/04/2018 10:25 am