Polski
Fora
English forum
Original Prusa XL (Single-Tool)
Hardware, firmware and software help
XL fails print fan RPM test after upgrade to 5.1.2
 
Notifications
Clear all

XL fails print fan RPM test after upgrade to 5.1.2  

    Ostatni Post
  RSS
Beef^3
 Beef^3
(@beef3)
Active Member
XL fails print fan RPM test after upgrade to 5.1.2

Upgraded to 5.1.2 and it said to re-run calibration tests.  First test failed print fan RPM test.  I can see both the print fan and hotend fan spin up during the test.  I can feel air blowing out from under the hotend.

Best Answer by Fallon:

https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-assembly-and-first-prints-troubleshooting/xl-dual-tool-print-fan-self-test-fails-on-both-extruders/

https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-hardware-firmware-and-software-help/fan-test-failed-but-all-fans-physically-work-and-software-pointing-to-random-ish-failed-fans/

Opublikowany : 28/12/2023 9:30 pm
StephenB
 StephenB
(@stephenb)
New Member
RE: XL fails print fan RPM test after upgrade to 5.1.2

I have the same issue. I updated to 5.1.2 and then started to receive the same 'fan RPM test' failure during the Self Test.

Opublikowany : 30/12/2023 7:15 am
Fallon
 Fallon
(@fallon)
Eminent Member
RE: XL fails print fan RPM test after upgrade to 5.1.2

https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-assembly-and-first-prints-troubleshooting/xl-dual-tool-print-fan-self-test-fails-on-both-extruders/

https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-hardware-firmware-and-software-help/fan-test-failed-but-all-fans-physically-work-and-software-pointing-to-random-ish-failed-fans/

Opublikowany : 02/01/2024 6:09 pm
Beef^3
 Beef^3
(@beef3)
Active Member
Topic starter answered:
RE: XL fails print fan RPM test after upgrade to 5.1.2

Removing the shroud for the print fan fixed the issue.  Thank you.

Opublikowany : 02/01/2024 8:04 pm
  All forum topics
  Previous Topic
Next Topic  
Share: