Notifications
Clear all
Strona 3 / 3
Wstecz
RE: Xl extruder stops
We change Dwarf Board and Motor… ran well 4-5 prints and fails again.
We have been asked by support to change the wiring and we are running again well. So far.
Lets see how long last….
Opublikowany : 19/10/2024 10:37 pm
RE: Xl extruder stops
Thank you for the reply. I guess it could be related to the wiring harness. There doesn’t seem to be much tension on the connector, but you never know. I’ll remove the connector and plug it back in and try the print again.
Opublikowany : 19/10/2024 10:53 pm
RE: Xl extruder stops
I don't think the cable will fix it. It’s the second time we change the cable and last time fails.
Definitively will be something on the Sandwich board.
I have another XL that is working fine. Same configuration, same Firmware and just the one fails.
just FYI i have around 3 months with this problem.
Opublikowany : 19/10/2024 10:57 pm
Strona 3 / 3
Wstecz