Notifications
Clear all

[Pronterface] no response to any command  

  RSS
ghe.leguen
(@ghe-leguen)
New Member
[Pronterface] no response to any command

Hi everyone, 

Fablab where I work gave me an old i3 with arduino mego for I can prototype and continue my work at home.

I'm in linux, and I connected printer to my claptop. Ti is ok. The printer move when I send it a command with graphic interface.

I tryed to calibrate Z axes, because the exruder tuch the bed. I look for send commands manualy. But any command have a response. I just can read (send M114 or other).

I tried in my windows to. But it's the same problem.

Have you got a solution for this problem ?

Best regards

ghe.leguen

 
Posted : 01/11/2020 10:51 am
Share: