Notifications
Clear all

Results input shaper  

Stránka 2 / 2
  RSS
bbuswier
(@bbuswier)
New Member
RE: Results input shaper

I think it depends a lot on the model you print. My experience is that IS does not work well with big top surfaces, it is just not smooth at all

Napsal : 19/08/2023 1:49 pm
Simon Tratter
(@simon-tratter)
Eminent Member
RE: Results input shaper

I printed an IS Test too, but there is no ideal Frequency to choose from. I printed this with 110 mm/s.

Y-axis

X-axis

Simon 🙂

Napsal : 06/11/2023 6:29 pm
Shushuda
(@shushuda)
Estimable Member
RE: Results input shaper

Those ripples on your X axis are way too excessive. Try to swap the pulleys between the axes and see if the ripples move to the other axis. If yes, then you have a faulty pulley. Replacing it should fix the ripples.

Posted by: @simon-tratter

I printed an IS Test too, but there is no ideal Frequency to choose from. I printed this with 110 mm/s.

Y-axis

X-axis

Simon 🙂

 

Napsal : 06/11/2023 8:46 pm
Simon Tratter se líbí
Stránka 2 / 2
Share: