12 minute Bonkers Benchy made me smile.

Page 2 / 2 Précédent

Dernier message

RSS

Koegmaster

(@koegmaster)

Membre

RE:

Hi All,

for me the 12 minute Benchy gets heavy layer shifts (see pictures). Am I the only one with this problem?

I do have my MK4 in the original enclosure though, maybe the Filament guide is a problem here?

Or do you think my belts are somehow loose? With the rest of my prints like e.g. the 27 minutes Benchy I do not have any problems though.

Ce message a été modifié il y a 1 year par Koegmaster

Publié : 09/06/2023 2:18 pm

carlmmii

(@carlmmii)

Trusted Member

RE: 12 minute Bonkers Benchy made me smile.

Check your Y-axis (bed) belt tension and make sure there's no debris on the rails that might prevent smooth motion. Also, check that your nozzle is secured with the thumbscrews tight.

Something is causing your Y-axis to shift, either from a skip in the belt, or an obstruction in bed movement either from the track area or from nozzle collision with the part.

Publié : 10/06/2023 7:37 am

Koegmaster

(@koegmaster)

Membre

RE: 12 minute Bonkers Benchy made me smile.

Posted by: @carlmmii

Check your Y-axis (bed) belt tension and make sure there's no debris on the rails that might prevent smooth motion. Also, check that your nozzle is secured with the thumbscrews tight.

Something is causing your Y-axis to shift, either from a skip in the belt, or an obstruction in bed movement either from the track area or from nozzle collision with the part.

Hi thanks for your answer, I wasn't able to test the last week but I just did another test print and the belt was clearly skipping, so I tighten it a little and now everything looks good!

Thanks

Publié : 16/06/2023 2:38 pm

carlmmii a aimé

Neolker

(@neolker)

Membre

RE: 12 minute Bonkers Benchy made me smile.

Still looks better than mine 🙂

Posted by: @koegmaster

Hi All,

for me the 12 minute Benchy gets heavy layer shifts (see pictures). Am I the only one with this problem?

I do have my MK4 in the original enclosure though, maybe the Filament guide is a problem here?

Or do you think my belts are somehow loose? With the rest of my prints like e.g. the 27 minutes Benchy I do not have any problems though.