Notifications
Clear all
waves on large flat PLA base
Running white Prusament PLA, a flat bottomed part 3mm thick. I am getting waves, enough to act like rumble strips as the nozzle goes over it. Using default settings other than no brim or skirt due to size.
Publié : 14/05/2022 2:54 am
RE: waves on large flat PLA base
Live Z too low?
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Publié : 14/05/2022 11:03 am
Agreed. Z too low.
Cheerio,
Publié : 14/05/2022 2:35 pm
Topic starter
answered:
RE: waves on large flat PLA base
That jives. I was 2 layers in then this appeared. My base layer did seem a bit low. It seems I have been backing it off a bit at a time, and need to back it off a bit more then. Thanks.
Publié : 14/05/2022 3:10 pm