Notifications
Clear all
Under extrusion after surface features
I seem to be getting under extrusion after surface features on one side when printing in PETG. The filament I am using is Devil Design grey PETG using the standard "Generic PETG" settings in PrusaSlicer. Does anyone know what might be causing this issue?
Publié : 26/03/2020 12:48 pm
RE: Under extrusion after surface features
which firmware are you on? there are some improvements (Adjustments to e-steps) in the latest RC firmware here : https://github.com/prusa3d/Prusa-Firmware-Buddy/releases/
Mini with FW:4.4.1 + SuperPINDA + Bondtech Heatbreak + PC4-M8 couplers + 1 piece boden
Publié : 26/03/2020 2:07 pm
Topic starter
answered:
RE: Under extrusion after surface features
That is a good point, it was on 4.0.4. I will print a new benchy on 4.05 and report back.
Publié : 26/03/2020 3:42 pm
Oxygen a aimé
Topic starter
answered:
RE: Under extrusion after surface features
Publié : 26/03/2020 6:11 pm
Topic starter
answered:
RE: Under extrusion after surface features
I managed to solve the issue by using the settings for Filamentum CPE instead of generic PET-G. I guess the issue was that it needed more heat.
Publié : 09/04/2020 11:40 am