Notifications
Clear all
Model with a lot of support on Heatbed doesn't stick to heatbed
I wanted to print this, with the side where the knob sticks out facing to the heatbed.
Problem: this needs a lot of support and with that setting the object doesn't stick on the heatbed.
Any advice?
Publié : 01/04/2021 7:55 am
RE: Model with a lot of support on Heatbed doesn't stick to heatbed
Good Morning Bamboo shaddow,
make sure your first layer calibration is good, and that your build plate is immaculately clean,
then try this file
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Publié : 01/04/2021 9:25 am