Notifications
Clear all

A more continuous first layer?  

  RSS
Steverd
(@steverd)
Trusted Member
A more continuous first layer?

Is there a setting to get a more continuous print of this snowflake?
In the photo, on the left you can see the printer is placing all of these tiny filaments on the print bed, not connected to anything at first.

The right side shows the print. It seems that there should be a setting in PrusaSlicer that is more continuous and not placing tiny parts all over the print bed.
Classic is a little better than Arachne, but not by much.

Any suggestions? Thank you for any ideas

 

Posted : 07/12/2022 9:51 pm
Share: